Attached is a simple file that behaves not the way I expect it to. After I press the reset button it draws two pixels on the screen. Same when I run it under emulator with the original PM BIOS.
However the fun starts when I try to run it on the device and press power-off button twice. Then I get a line of 8 pixels (the whole byte is set) instead of only two pixels. Pressing reset button brings it back to normal.
Moreover when I run it under emulator with the FreeBIOS the power-off button doesn't work at all.
What I am doing wrong here?
PM development, programming, hacking and all that fun stuff.
1 post • Page 1 of 1